JobProof® Start free

EICR codes under BS 7671 Amendment 4:2026

Updated 20 November 2026.

BS 7671:2018+A4:2026 was published on 15 April 2026, and the earlier amendments were withdrawn on 15 October 2026. Every EICR you issue now follows Amendment 4. One change matters on every report: FI is now advisory, as C3 is. Neither changes the overall result.

The four codes

Before Amendment 4, the FI code read "further investigation required without delay".

The IET's guidance is that FI is for a potential safety issue that could not be fully determined because of the extent or limitations of the inspection, and that it should not be needed in most cases.

What makes a report unsatisfactory

Any C1 or C2 makes the overall result unsatisfactory. Under Amendment 4, a C3 or an FI on its own does not. The IET explained the change in Wiring Matters, July 2026: C3 and FI are now separate from C1 and C2.

Rented homes in England

The electrical safety standards regulations for rented homes in England (SI 2020/312) require an inspection and test at least every five years. They now apply to social housing as well as private lets. The tenant gets a copy of the report within 28 days. Where the report shows the landlord is, or may be, in breach of the standards and requires further investigative or remedial work, the landlord must have it done by a qualified person within 28 days, or sooner if the report says so.

The government's guidance for landlords (published 1 November 2025, before Amendment 4) describes FI as "further investigation required without delay", and says the landlord must make sure further investigative work identified by the inspector is carried out. On the Amendment 4 form, FI reads "further investigation is advised" and does not change the overall result.

Regulation 3(4) applies where a report "indicates that a landlord is or is potentially in breach of the duty" and "requires the landlord to undertake further investigative or remedial work". What a report requires is what the inspector writes in it.

Wales and Scotland have their own rules.

Coding observations in JobProof®

You choose the code for every observation, and the app works out the overall result from your codes: unsatisfactory with any C1 or C2. You can still mark the report unsatisfactory yourself. Scan the board and the app reads the main switch and each device's type and rating into the schedule, for you to check. Your readings are yours: typed in, or read from a photo of your tester's screen into the box you pick, for you to confirm. Every PDF carries a QR code.

Pricing

Pay as you go. No subscription.

The price you see is the total you pay, including any tax.

Start free

Talk it through with other engineers: join the discussion on Facebook, or follow JobProof on Facebook.

Sources